Daewoo DIM-44 User Manual

User’s Manual Be sure ice maker is standing upright 24 hours prior to plug-in.

9accordance with the National Electrical Code and local codes and ordinances, is required. IMPORTANT: Do not kink or pinch the power supply cord betw

10Leveling the ice maker It is important for the ice maker to be leveled in order to work properly. Otherwise water will not flow properly through th

114. Position the door on the bottom hinge. 5. Align the door on the bottom hinge and replace the top hinge and top hinge mat. 6. Replace top hing

12Water Supply The water supply should be ready at the point of installation. The water supply pressure should be a minimum of 15 psig with a stati

132. All horizontal runs of drain lines must have a fall of ¼” per foot. An air gap will likely be required between the ice maker drain tube and the

14OPERATION Final Check List before Operation 1. Have all packing materials and tape been removed from the interior and exterior of the ice maker?

15ice storage bin. 4. When the ice storage bin is full, the sheet of cubes will not fall completely and will hold the bin-full probe open. The mac

16 Normal sounds Your new ice maker may make sounds that are not familiar to you. Most of the new sounds are normal. Hard surfaces lik

176. Leave the door open to allow for circulation and to prevent mold and mildew. 7. Leave water supply line and power cord disconnected until read

18 Exterior cleaning The door and cabinet may be cleaned with a mild detergent and warm water solution such as 1 oz. of dishwashing liquid mixe

1TABLE OF CONTENTS Page ICE MAKER SAFETY ...

19Condenser cleaning A dirty or clogged condenser prevents proper airflow, reduces ice making capacity, and causes higher than recommended operating

201. Make sure that all the ice is off the evaporator. If ice is being formed, wait until the cycle is completed, then press the machine’s ON/OFF sw

21Control panel: Description of LEDs and buttons: 1. Bin Full (Red) LED: Bin full indicator light When this is lit, the ice storage bin

22MAJOR FUNCTIONS 1. The operating procedure is completely automatic. 2. When the ice storage bin is full of ice cubes，the machine stops making ice

23TROUBLESHOOTING Before Calling for Service If the unit appears to be malfunctioning, read through the OPERATION section of this manual first. If t

24Cubes are partially formed or are white on the bottom. Not enough water in the water trough. Check if the water supply pressure is below 15 psig.

2ICE MAKER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on you

3IMPORTANT SAFEGUARDS Before the ice maker is used, it must be properly positioned and installed as described in this manual, so read the manual care

4• Do not kink or pinch the power supply cord between the ice maker and cabinet. • The fuse (or circuit breaker) size should be 15 amperes. • It i

5Extension Cord Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with t

6COMPONENT LOCATIONS Water distribution tube Evaporator (ice mold) Water trough Float Ice storage bin Control

7 ICE MAKER INSTALLATION Unpacking Remove packaging materials IMPORTANT: Do not remove any permanent instruction labels or the data label

8 • This ice maker should be properly installed by qualified personnel. • To ensure proper ventilation for your ice maker, the front of the unit m